Drying a structure correctly isn't about running a few fans and hoping — it's a calculated process based on temperature, humidity, and airflow readings.
We calculate air mover and dehumidifier placement using psychrometric formulas, not a flat per-room equipment count.
We calculate drying requirements using temperature and humidity data, not a flat per-room rule.
Low Grain Refrigerant dehumidifiers pull significantly more moisture from the air than consumer-grade units.
Thermal imaging cameras reveal moisture patterns behind walls and under flooring that aren't visible to the eye.
Daily logs give you and your insurer verifiable proof of progress, not a technician's word.
Below is the calculated, documented process our Soda Springs, CA teams follow.
The assessment sets the baseline every later reading gets measured against.
Thermal cameras scan walls, ceilings, and flooring to reveal moisture invisible to the naked eye.
We position air movers to create directed airflow across wet surfaces based on the assessment.
Daily monitoring confirms equipment is working and adjusts the plan if progress stalls.
We adjust drying speed for sensitive materials like hardwood and cabinetry to prevent secondary damage.
The job closes only once moisture readings match the documented dry standard for each material type.
Tell our Soda Springs, CA dispatcher about the current condition so we can prepare the right diagnostic equipment.
A technician arrives with thermal imaging cameras and moisture meters ready to assess.
A full diagnostic assessment comes before any equipment placement or pricing.
A written verification report backs the final sign-off.
"The thermal imaging found moisture behind a wall that looked completely fine from the outside. Would have missed it otherwise." — Julian R.
"They came back every single day to take readings and showed me the numbers improving. Felt like real science, not guesswork." — Monique T.
"Our hardwood floor didn't warp because they slowed the drying process down specifically for it." — Grant P.
We rely on moisture meters and thermal imaging, not appearance alone.
Psychrometrics uses scientific formulas to size the drying plan to the actual moisture load.
Typical drying time is 3-5 days for standard materials, longer for sensitive ones like hardwood.
You'll see the actual numbers improve each day through documented logs.
Yes, we use slower, controlled drying specifically calibrated for hardwood to prevent warping.
We treat flat readings as a signal to recalculate, not something to wait out.
If your property is in or near Soda Springs, a crew can typically respond the same day.
One call starts the psychrometric assessment process.
Call +1-844-833-1325